Ideas and practical use of hydraulic gear oil pump design


Release time:

2020-01-04

Taking into account the actual working conditions of hydraulic gear oil pumps, the design of the floating combined sleeve should be able to reduce the radial force of the gear pump, reduce noise, provide axial compensation. Specific design ideas are as follows:

Taking into account the actual working conditions of hydraulic gear oil pumps, the design of the floating combined sleeve should be able to reduce the radial force of the gear pump, reduce noise, provide axial compensation. Specific design ideas are as follows:

(1) hydraulic compression force should be greater than the hydraulic separation force, but can not be too large, the actual compression force of 1.2 times the separation force;.
(2) Combined sleeve and gear working surface in the import and export direction are unloading groove, to avoid the phenomenon of gear pump oil trapped; (3) Select the gear pump to be used in the gear pump; (4) Select the gear pump to be used in the gear pump.

(4) The sleeve should have good lubrication, can adapt to the thin oil or even no oil lubrication conditions.

I. Side plate design:

Side plate material can be selected lead bronze, under limited circumstances can be made of modified polytetrafluoroethylene. The side plate is connected with the pump body using a stop table.

Hydraulic gear oil pump there is a radial force imbalance, gear shaft deformation bias pump body low-pressure area, may produce scrape boring phenomenon, at the same time will make the bushing floating poor, and reduce the working life of the bearing. In the side plate design using the method of increasing high-pressure diversion groove, increase the range of high-pressure oil area of the gear pump, only in the pump inlet before the first 2 to 3 teeth to play a sealing role, so the radial force on the gears to get partially balanced, thus reducing the radial unbalance force.

The structure of external gear pumps leads to the phenomenon of oil trapping, and the opening of unloading grooves on the side plate is a conventional method to mitigate the phenomenon of oil trapping. Under the premise of guaranteeing that the import and export are not connected to each other, when the trapped oil area is reduced, the outlet unloading groove is connected to the pump outlet, and when the trapped oil area is increased, the inlet unloading groove is connected to the spring inlet. Reasonable design of the trapped oil area and unloading slot can improve the working performance of the gear pump, the specific design method is a lot, here will not be specifically expanded.

Second, the actual use:

Due to the complexity of the actual hydraulic gear oil pump sleeve force, combined torque calculation method is quite cumbersome, here only provide a design idea to approximate the formula for calculation. In the actual design process, you can refer to the above design ideas, the use of CFD simulation method of the sleeve of the various stresses for detailed calculations, can further increase the design accuracy.

Key words: