Triplex gear oil pump application attention to technical problems


Release time:

2019-06-08

The disassembly and decomposition of the triplex gear oil pump should be carried out in a clean place, after the removed fittings are cleaned with gasoline or diesel fuel, the wear state of each fitting is carefully checked to make sure that it can be continued to be used, and then the fittings that can be continued to be used are carefully put away in order.

Technical requirements when assembling triplex gear oil pump:

1, when assembling, each fitting bonding surface and friction surface should be coated with oil, self-tightening oil package to the oil pump cover, shall be pressed to the bottom, and should not damage the sealing table.

2、Clean the whole fittings with gasoline or diesel fuel, and carefully check the technical status of each fitting. Assembly, the requirements of the active gear and the same width of the slave gear, in order to protect the oil pump work gear end face and sleeve end face fit tight; by the set of gears assembled into the casing, should be guaranteed 0.10-0.12mm axial clearance; small sealing ring should be higher than the ring 榑, there should be a pre-compression of 0.40-0.55mm compression of the compiled amount of the pre-compressed amount of the large sealing ring for 0.6-0.7mm

3, the sleeve of the pressure relief 榑 beneficial to remove the closed volume generated when the gear mesh, so when assembled, pay attention to the location of the pressure relief. Pressure relief piece and sealing ring should be in the suction chamber side, that is, the oil pump casing has "inlet" big hole on the side of the word.

4, screw the pump cover to the shell screws, should be divided into several times alternately rotating view, the torque is 49 ~ 59N-m.

5、Assembled triplex gear oil pump, when rotating the main gear by hand, it should be smooth without jamming phenomenon, and the rotating torque should not be greater than 3N-m.

When disassembling the gear pump, the following issues should be noted:

1, the gear pump is a precision parts, in the absence of judgment failure does occur in the gear pump, generally do not easily dismantle.

2、After disassembling the gear pump assembly, the oil and dust outside the oil pump assembly should be cleaned first. Before disassembly and decomposition, the application of steel (as far as possible with a marker pen) in the pump cover and the pump body on a mark in order to mark the assembly.

3, wear and tear is serious, can not continue to use the accessories, should be a set or a pair of replacement of new parts. Such as gears should be replaced by a pair, otherwise the two gears of the poor state of the gears will affect the pressure of oil transmission.

4、Disassembly and decomposition of triplex gear oil pumps should be carried out in a clean place, after cleaning the removed accessories with gasoline or diesel fuel, carefully check the fittings of the wear of the public relations state, to confirm whether it can continue to use, and then can continue to use the accessories, carefully put in order.

Key words: